Search results
Results from the WOW.Com Content Network
This refers to the portion of the well across the production or injection zone. The well designer has many tools and options available to design the lower completion (downhole completion) according to the conditions of the reservoir. Typically, the lower completion is set across the productive zone using a liner hanger system, which anchors the ...
The production liner has the same function as a complete string of production casing. A typical casing arrangement in a well is shown in the diagram below. In this case, the surface casing is set to a depth of about 3,000 ft (910 m). Two intermediate strings are set in this well — a 13 + 3 ⁄ 8 in (340 mm) string and a 9 + 7 ⁄ 8 in (250 mm ...
Drill pipe (#16) is a joint of hollow tubing used to connect the surface equipment to the bottom hole assembly (BHA) and acts as a conduit for the drilling fluid. In the diagram, these are stands of drill pipe which are 2 or 3 joints of drill pipe connected and stood in the derrick vertically, usually to save time while tripping pipe.
Petroleum engineering is a field of engineering concerned with the activities related to the production of hydrocarbons, which can be either crude oil or natural gas. [1] Exploration and production are deemed to fall within the upstream sector of the oil and gas industry.
Petroleum production engineering is a subset of petroleum engineering. Petroleum production engineers design and select subsurface equipment to produce oil and gas well fluids . [ 1 ] They often are degreed as petroleum engineers , although they may come from other technical disciplines (e.g., mechanical engineering , chemical engineering ...
When the well has been drilled, it is completed to provide an interface with the reservoir rock and a tubular conduit for the well fluids. The surface pressure control is provided by a Christmas tree, which is installed on top of the wellhead, with isolation valves and choke equipment to control the flow of well fluids during production.
The right hand valve is often called the flow wing valve or the production wing valve, because it is in the flowpath the hydrocarbons take to production facilities (or the path water or gas will take from production to the well in the case of injection wells). The left hand valve is often called the kill wing valve (KWV).
A production separator is used to separate the produced well fluid from a well, group of wells, or a lease on a daily or continuous basis. Production separators can be vertical, horizontal, or spherical. They can be two-phase or three-phase. Production separators range in size from 12 in. to 15 ft in diameter, with most units ranging from 30 in ...