Search results
Results from the WOW.Com Content Network
A disconnect tone in telephony is a tone provided to the remaining party to a call after the remote party hangs up. [ 1 ] [ 2 ] Typically, the disconnect tone is a few cycles of the reorder , busy , or the off-hook tone (e.g. in US), or between five and fifteen seconds of the Number Unobtainable tone (e.g. in UK).
Calling party control (CPC), or forward disconnect, is a telecommunication signal sent from a central office to the telephone subscriber's equipment to indicate that the calling party has hung up. This indicates that answering machines should stop recording, notifies conference call bridges that a participant has left or removes an abandoned ...
A disconnect tone in telephony is a tone provided to the remaining party to a call after the remote party hangs up. Typically, the disconnect tone is a few cycles of the reorder , busy , or the off-hook tone (e.g. in US), or between five and fifteen seconds of the Number Unobtainable tone (e.g. in UK).
Please check your main telephone and extensions, then try your call again. Thank you." The message may be repeated, then followed by a loud, rasping off-hook tone intended to remain audible even if the handset is on the desktop instead of at the subscriber's ear. This tone is louder than the standard busy/fast busy signal.
A disconnect tone in telephony is a tone provided to the remaining party to a call after the remote party hangs up. Typically, the disconnect tone is a few cycles of the reorder , busy , or the off-hook tone (e.g. in US), or between five and fifteen seconds of the Number Unobtainable tone (e.g. in UK).
The weight of the receiver depresses the spring-loaded switchhook thereby disconnecting the idle instrument (except its bell) from the telephone line. One of two possible signaling states, such as tone or no tone, or ground connection versus battery connection. Note: if on-hook pertains to one state, off-hook pertains to the other.
Multifrequency signaling is a technological precursor of dual-tone multi-frequency signaling (DTMF, Touch-Tone), which uses the same fundamental principle, but was used primarily for signaling address information and control signals from a user's telephone to the wire-center's Class-5 switch. DTMF uses a total of eight frequencies.
The tone frequencies, as defined by the precise tone plan, are selected such that harmonics and intermodulation products will not cause an unreliable signal. No frequency is a multiple of another, the difference between any two frequencies does not equal any of the frequencies, and the sum of any two frequencies does not equal any of the ...