enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Salinity - Wikipedia

    en.wikipedia.org/wiki/Salinity

    A sample of seawater from most locations with a chlorinity of 19.37 ppt will have a Knudsen salinity of 35.00 ppt, a PSS-78 practical salinity of about 35.0, and a TEOS-10 absolute salinity of about 35.2 g/kg. The electrical conductivity of this water at a temperature of 15 °C is 42.9 mS/cm. [6] [12]

  3. Saline water - Wikipedia

    en.wikipedia.org/wiki/Saline_water

    The USGS salinity scale defines three levels of saline water. The salt concentration in slightly saline water is 1,000 to 3,000 ppm (0.1–0.3%); in moderately saline water is 3,000 to 10,000 ppm (0.3–1%); and in highly saline water is 10,000 to 35,000 ppm (1–3.5%).

  4. Seawater - Wikipedia

    en.wikipedia.org/wiki/Seawater

    Seawater, or sea water, is water from a sea or ocean.On average, seawater in the world's oceans has a salinity of about 3.5% (35 g/L, 35 ppt, 600 mM). This means that every kilogram (roughly one liter by volume) of seawater has approximately 35 grams (1.2 oz) of dissolved salts (predominantly sodium (Na +

  5. Per mille - Wikipedia

    en.wikipedia.org/wiki/Per_mille

    Salinity. Seawater salinity is often expressed per mille. Average marine salinity is about 35 parts per thousand or 35‰ (3.5%). ... 1‱, 1 pcm and 1 ppm as ...

  6. Parts-per notation - Wikipedia

    en.wikipedia.org/wiki/Parts-per_notation

    At 1 ppm the solution is a very pale yellow. As the concentration increases the colour becomes a more vibrant yellow, then orange, with the final 10,000 ppm a deep red colour. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...

  7. Total dissolved solids - Wikipedia

    en.wikipedia.org/wiki/Total_dissolved_solids

    where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]

  8. Properties of water - Wikipedia

    en.wikipedia.org/wiki/Properties_of_water

    [23] 0.23 ppm of the earth's mass is water and 97.39% of the global water volume of 1.38 × 10 9 km 3 is found in the oceans. [ 84 ] Water is far more prevalent in the outer Solar System, beyond a point called the frost line , where the Sun's radiation is too weak to vaporize solid and liquid water (as well as other elements and chemical ...

  9. List of bodies of water by salinity - Wikipedia

    en.wikipedia.org/wiki/List_of_bodies_of_water_by...

    This is a list of bodies of water by salinity that is limited to natural bodies of water that have a stable salinity above 0.05%, at or below which water is considered fresh. Water salinity often varies by location and season, particularly with hypersaline lakes in arid areas, so the salinity figures in the table below should be interpreted as ...