enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. DDR5 SDRAM - Wikipedia

    en.wikipedia.org/wiki/DDR5_SDRAM

    Double Data Rate 5 Synchronous Dynamic Random-Access Memory (DDR5 SDRAM) is a type of synchronous dynamic random-access memory.Compared to its predecessor DDR4 SDRAM, DDR5 was planned to reduce power consumption, while doubling bandwidth. [5]

  3. Registered memory - Wikipedia

    en.wikipedia.org/wiki/Registered_memory

    There is much confusion between registered and ECC memory; it is widely thought that ECC memory (which may or may not be registered) will not work at all in a motherboard without ECC support, not even without providing the ECC functionality, although the compatibility issues actually arise when trying to use registered memory (which often ...

  4. Memory timings - Wikipedia

    en.wikipedia.org/wiki/Memory_timings

    Memory timings or RAM timings describe the timing information of a memory module or the onboard LPDDRx. Due to the inherent qualities of VLSI and microelectronics, memory chips require time to fully execute commands. Executing commands too quickly will result in data corruption and results in system instability.

  5. Computer compatibility - Wikipedia

    en.wikipedia.org/wiki/Computer_compatibility

    An example is RAM chips, some of which can run at a lower (or sometimes higher) clock rate than rated. [2] Hardware that was designed for one operating system may not work for another, if device or kernel drivers are unavailable. As an example, Android is not able to be run on a phone with iOS. [3]

  6. Dynamic random-access memory - Wikipedia

    en.wikipedia.org/wiki/Dynamic_random-access_memory

    EDO RAM, sometimes referred to as hyper page mode enabled DRAM, is similar to fast page mode DRAM with the additional feature that a new access cycle can be started while keeping the data output of the previous cycle active.

  7. Overclocking - Wikipedia

    en.wikipedia.org/wiki/Overclocking

    The purpose of overclocking is to increase the operating speed of a given component. [3] Normally, on modern systems, the target of overclocking is increasing the performance of a major chip or subsystem, such as the main processor or graphics controller, but other components, such as system memory or system buses (generally on the motherboard), are commonly involved.

  8. Random-access memory - Wikipedia

    en.wikipedia.org/wiki/Random-access_memory

    Within the RAM device, multiplexing and demultiplexing circuitry is used to select memory cells. Typically, a RAM device has a set of address lines A 0 , A 1 , . . . A n {\displaystyle A_{0},A_{1},...A_{n}} , and for each combination of bits that may be applied to these lines, a set of memory cells are activated.

  9. ReadyBoost - Wikipedia

    en.wikipedia.org/wiki/ReadyBoost

    As the price of RAM decreased and more RAM was installed in computers, the mitigations provided by ReadyBoost to systems with insufficient memory decreased. The core idea of ReadyBoost is that a flash memory (e.g. a USB flash drive or an SSD ) has a much faster seek time than a typical magnetic hard disk (less than 1 ms), allowing it to satisfy ...