enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fixture (tool) - Wikipedia

   en.wikipedia.org/wiki/Fixture_(tool)

   A common type of fixture, used in materials tensile testing (Grip-Engineering). A fixture is a work-holding or support device used in the manufacturing industry. [1] [2] Fixtures are used to securely locate (position in a specific location or orientation) and support the work, ensuring that all parts produced using the fixture will maintain conformity and interchangeability.

3. Rail fastening system - Wikipedia

   en.wikipedia.org/wiki/Rail_fastening_system

   Common sizes are from 9 ⁄ 16 to 10 ⁄ 16 inch (14 to 16 mm) square and 5 + 1 ⁄ 2 to 6 inches (140 to 150 mm) long. [10]: 582–583 A rail spike is roughly chisel-shaped and with a flat edged point; the spike is driven with the edge perpendicular to the grain, which gives greater resistance to loosening. [11]

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 22 ] : 149 [ 19 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

5. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.

6. Angle plate - Wikipedia

   en.wikipedia.org/wiki/Angle_plate

   An angle plate is a work holding device used as a fixture in metalworking. Angle plates are used to hold workpieces square to the table during marking out operations. Adjustable angle plates are also available for workpieces that need to be inclined, usually towards a milling cutter .

7. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A 14 mm shank similar to SDS-plus, designed for hammers from 2 to 5 kg. The grip area is increased to 212 mm 2 (0.329 sq in) and the shank is inserted 70 mm. This size remained uncommon and was discontinued in 2009. [5] SDS-max An 18 mm shank with three open grooves and locking segments rather than balls. It is designed for hammers over 5 kg.