enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Steel square - Wikipedia

   en.wikipedia.org/wiki/Steel_square

   The hip or valley rafter also connects the ridge to the plate, but lies at a 45-degree angle to the common rafter. This number gives the length of the hip or valley rafter per seventeen units of run. Difference in lengths jacks. The jack rafters lie in the same plane as the common rafter but connect the top plate (the wall) or ridge board to ...

3. Speed square - Wikipedia

   en.wikipedia.org/wiki/Speed_square

   Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.

4. Rafter - Wikipedia

   en.wikipedia.org/wiki/Rafter

   Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.

5. Dragon beam - Wikipedia

   en.wikipedia.org/wiki/Dragon_beam

   The dragon beam lies parallel to and below a hip rafter and carries the rafter. The dragon beam is carried by the wall on the outer end and by a horizontal piece between the two walls on the inside end. There are conflicting usages for this term in the U.K. and U.S.A. (see below). The most common usage seems to be combination dragon beam/cross tie.

6. Timber roof truss - Wikipedia

   en.wikipedia.org/wiki/Timber_roof_truss

   Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.

7. Knee wall - Wikipedia

   en.wikipedia.org/wiki/Knee_wall

   A knee wall is a short wall, typically under three feet (one metre) in height, used to support the rafters in timber roof construction. In his book A Visual Dictionary of Architecture, Francis D. K. Ching defines a knee wall as "a short wall supporting rafters at some intermediate position along their length."

8. Hip roof - Wikipedia

   en.wikipedia.org/wiki/Hip_roof

   The "hips" and hip rafters sit on an external corner of the building and rise to the ridge. Where the building has an internal corner, a valley makes the join between the sloping surfaces (and is underlain by a valley rafter). Hip roofs have the advantage of giving a compact, solid appearance to a structure. The roof pitch (slope) may vary.

9. Hammerbeam roof - Wikipedia

   en.wikipedia.org/wiki/Hammerbeam_roof

   A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.