Search results
Results from the WOW.Com Content Network
The gas-generator cycle, also called open cycle, is one of the most commonly used power cycles in bipropellant liquid rocket engines. Propellant is burned in a gas generator (or "preburner") and the resulting hot gas is used to power the propellant pumps before being exhausted overboard and lost.
The basic operation of the gas turbine is a Brayton cycle with air as the working fluid: atmospheric air flows through the compressor that brings it to higher pressure; energy is then added by spraying fuel into the air and igniting it so that the combustion generates a high-temperature flow; this high-temperature pressurized gas enters a ...
In a simple cycle gas-turbine, also known as open-cycle gas-turbine (OCGT) generators, hot gas drives a gas turbine to generate electricity. This type of plant is relatively cheap to build and can start very quickly, but due to its lower efficiency is at most only run for a few hours a day as a peaking power plant. [8]
The LMS100 PA produces approximately 100 MW at an efficiency of around 46% LHV in open cycle operation. It is currently the largest and most efficient aero-derivative gas turbine. It is able to produce full rated power in under 10 minutes. [citation needed] The LMS100 comprises a low-pressure compressor, an intercooler, a supercore and a power ...
A combined cycle power plant is an assembly of heat engines that work in tandem from the same source of heat, converting it into mechanical energy. On land, when used to make electricity the most common type is called a combined cycle gas turbine (CCGT) plant, which is a kind of gas-fired power plant.
Example of a real system modelled by an idealized process: PV and TS diagrams of a Brayton cycle mapped to actual processes of a gas turbine engine Thermodynamic cycles may be used to model real devices and systems, typically by making a series of assumptions to reduce the problem to a more manageable form. [ 2 ]
A simple-cycle combustion turbine (SCCT) is a type of gas turbine typically used in the power generation, aviation , and oil and gas industries (for electricity generation and mechanical drives). The simple-cycle combustion turbine follows the Brayton Cycle and differs from a combined cycle operation in that it has only one power cycle (i.e. no ...
The gas turbine cycle is used for all modern gas turbine and turbojet engines, however simple cycle turbines are often recuperated to improve efficiency and these recuperated turbines more closely resemble Ericsson's work. Ericsson eventually abandoned the open cycle in favor of the traditional closed Stirling cycle.