Search results
Results from the WOW.Com Content Network
The gauge (in American English or more commonly referred to as bore in British English) of a firearm is a unit of measurement used to express the inner diameter (bore diameter) and other necessary parameters to define in general a smoothbore barrel (compare to caliber, which defines a barrel with rifling and its cartridge).
Although not originally designed for handguns, several rifle and shotgun cartridges have also been chambered in a number of large handguns, primarily in revolvers like the Phelps Heritage revolver, Century Arms revolver, Thompson/Centre Contender break-open pistol, Magnum Research BFR, and the Pfeifer Zeliska revolvers.
Common rifle cartridges, from the largest .50 BMG to the smallest .22 Long Rifle with a $1 United States dollar bill in the background as a reference point. This is a table of selected pistol/submachine gun and rifle/machine gun cartridges by common name. Data values are the highest found for the cartridge, and might not occur in the same load ...
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
Originally adapted from Hawks Rifle Cartridges; Some cartridge info can be found at 6mmbr cartridge diagrams; Reloading information at Load Data; Cartridge diagrams at Steve's Pages; Cartridge and reloading info can be found at Accurate Reloading
The MP-443 Grach and GSh-18 pistols and PP-19 Vityaz, PP-90M1 and PP-2000 submachine guns were designed for use with this overpressure cartridge. Jane's Infantry Weapons stated in 2003 that the 7N21 cartridge combined the 9×19mm Parabellum dimensions with a 9×21mm Gyurza bullet design and was developed specifically for the penetration of body ...
A barrel of another caliber or length can be installed and pinned in place, the fore-end replaced, and the pistol is ready to shoot with a different barrel and pre-aligned sights. This allowed easy changes of calibers, sights, and barrel lengths, with only a flat screwdriver being required for this change. [2]
Conventional eight groove rifling on the left, and octagonal polygonal rifling on the right. Polygonal rifling (/ p ə ˈ l ɪ ɡ ə n əl / pə-LIG-ə-nəl) is a type of gun barrel rifling where the traditional sharp-edged "lands and grooves" are replaced by less pronounced "hills and valleys", so the barrel bore has a polygonal (usually hexagonal or octagonal) cross-sectional profile.