Search results
Results from the WOW.Com Content Network
Some CFG examples: (a) an if-then-else (b) a while loop (c) a natural loop with two exits, e.g. while with an if...break in the middle; non-structured but reducible (d) an irreducible CFG: a loop with two entry points, e.g. goto into a while or for loop A control-flow graph used by the Rust compiler to perform codegen.
Example of a system context diagram. [1] A system context diagram in engineering is a diagram that defines the boundary between the system, or part of a system, and its environment, showing the entities that interact with it. [2] This diagram is a high level view of a system. It is similar to a block diagram.
Converting ordinary code into SSA form is primarily a matter of replacing the target of each assignment with a new variable, and replacing each use of a variable with the "version" of the variable reaching that point. For example, consider the following control-flow graph: An example control-flow graph, before conversion to SSA
The code in a basic block has: One entry point, meaning that no code within it is the destination of a jump instruction anywhere in the program.; One exit point, meaning that only the last instruction can cause the program to begin executing code in a different basic block.
UML Diagrams used to represent the development view include the Package diagram and the Component diagram. [2] Physical view: The physical view (aka the deployment view) depicts the system from a system engineer's point of view. It is concerned with the topology of software components on the physical layer as well as the physical connections ...
This file contains additional information, probably added from the digital camera or scanner used to create or digitize it. If the file has been modified from its original state, some details may not fully reflect the modified file.
A dynamic call graph is a record of an execution of the program, for example as output by a profiler. Thus, a dynamic call graph can be exact, but only describes one run of the program. A static call graph is a call graph intended to represent every possible run of the program.
Familiarity with unified modeling language (UML) is needed to construct a system sequence diagram. These models show the logic behind the actors (people who affect the system) and the system in performing the task. Reading a sequence diagram begins at the top with the actor(s) or the system(s) (which is located at the top of the page).