Ads
related to: checking diodes in circuit
Search results
Results from the WOW.Com Content Network
In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker) across the chosen path.
Transistor testers have the necessary controls and switches for making the proper voltage, current and signal settings. A meter with a calibrated "good" and "bad" scale is on the front. In addition, these transistor testers are designed to check the solid-state diodes. There are also testers for checking high transistor and rectifiers.
Diode circuit implementing AND in active-high logic. Note: in analog implementation exact output currents will be different from +5V supply. This circuit mirrors the previous gate: the diodes are reversed so that each input connects to the cathode of a diode and all anodes are connected together to the output, which has a pull-up resistor.
Clipper (electronics), a circuit that imposes a fixed limit and does not offset the signal; Envelope detector, a circuit that outputs the maximum (or minimum); a clamper with the diode and capacitor exchanged; Schottky diode; Snubber, a circuit that reduces dV/dt or limits peak voltage, in order to reduce arcing or breakdown
The word diode however was already in use, as were triode, tetrode, pentode, hexode, as terms of multiplex telegraphy. [23] Although all diodes rectify, "rectifier" usually applies to diodes used for power supply, to differentiate them from diodes intended for small signal circuits.
The diode, a nonlinear device, is in series with a linear circuit consisting of a resistor, R and a voltage source, V DD. The characteristic curve (curved line) , representing the current I through the diode for any given voltage across the diode V D , is an exponential curve.
Diagram of a simple circuit with an inductance L and a flyback diode D.The resistor R represents the resistance of the inductor's windings. A flyback diode is any diode connected across an inductor used to eliminate flyback, which is the sudden voltage spike seen across an inductive load when its supply current is suddenly reduced or interrupted.
For two-terminal devices (such as diodes and DIACs), this is sufficient to fully characterize the device. The curve tracer can display all of the interesting parameters such as the diode's forward voltage, reverse leakage current, reverse breakdown voltage, and so on. For triggerable devices such as DIACs, the forward and reverse trigger ...
Ads
related to: checking diodes in circuit