enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

3. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   Thus it is today common to encounter a Whitworth hexagon which does not fit the nominally correct spanner and following the previous example, a more modern spanner may be marked 7 ⁄ 16 BS to indicate that they have a jaw size of 0.710 in and designed to take either the (later) 7 ⁄ 16 BSW or 7 ⁄ 16 BSF hexagon. [10] [11] [12]

4. British Association screw threads - Wikipedia

   en.wikipedia.org/wiki/British_Association_screw...

   BS 93:1951 — Specification for British Association (B.A.) screw threads with tolerances for sizes 0 B.A. to 16 B.A. BS 93:2008 — British Association (B.A.) screw threads — Requirements The angle of the thread is 47.5° [ 4 ] : 2 and the depth of thread is 0.6 times the pitch with rounded tops and bottoms.

5. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Even though #14 and #16 screws are still available, they are not as common as sizes #0 through #12. [citation needed] Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs.

6. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

7. AOL Calendar - You're almost there, but your web browser ...

   calendar.aol.com

   Upgrade to a faster, more secure version of a supported browser. It's free and it only takes a few moments:

8. British Standard Cycle - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Cycle

   Cycle thread in 7 ⁄ 16 and 1 ⁄ 2 inch sizes also come in 20 tpi and 24 tpi options. 1/4" diameter cycle thread nuts and bolts have the same 26tpi as 1/4" BSF, which means that they will fit each other in this diameter only.

9. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!