Ads
related to: 5.7 sbc rods stroker clearance kit for sale ford
Search results
Results from the WOW.Com Content Network
A 289 Ford small-block V8 in a 1965 Ford Mustang. The 289 cu in (4.7 L) V8 was introduced in April 1963, carrying the Challenger name over from the 260 [3] and replacing it as the base V8 for full-sized Fords. Bore was expanded to 4.00 in (101.6 mm), becoming the standard for most small block Ford engines. Stroke remained at 2.87 inches.
The 335 series engines were used in mid- and full-sized cars and light trucks, (351M/400 only) at times concurrently with the Ford small block family 351 "Windsor", in cars. These engines were also used as a replacement for the FE V8 family in both the car and truck lines. The 335 series only outlived the FE series by a half-decade, being ...
Also in 1965, Ford and Carroll Shelby began production of a new and improved Cobra using a 427 cubic inches (7 L) FE side-oiler in place of the original's 289 cu in (4.7 L) Windsor small-block. A new chassis was built enlarging 3" main tubing to 4", with coil springs all around. The new car also had wide fenders and a larger radiator opening.
The connecting rod was also 400 specific being 5.565 in (141.4 mm) as opposed to the 5.7 in (144.8 mm) rod used in all other small-block Chevrolet engines. The 400 was made in 4-bolt main journal from 1970 to 1972 and in 2-bolt main journal from 1973 to 1979.
While Group A disappeared after the VN model range, the fuel injected 5.0-litre; 304.3-cubic-inch (4,987 cc) engine, often referred to by its nickname, The Iron Lion, was offered in Commodores until the VS III Commodore utility in 2000, although there were no longer V8 VS III utilities available for sale during the latter part of 2000.
All generation-2 small-block Olds V8s used the same stroke of 3.385 in (86 mm). The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material ...
Other than that, this engine is vastly different from the Gen-1 model. The Gen-1 engine is physically the size of a big-block Ford or GM engine, and is sometimes called a "big-block". The Gen-2 is closer to the physical size of U.S.-made small-block V8s except for the bore centers, which are the same as some big-block engines.
Even with the benefit of today's technology (aftermarket rods and stroker cranks), the upper limit of a Y-block is about 348 cu in (5.7 L), while the Chevrolet could be modified well past the factory limit of 400 cu in (6.6 L). The result was the introduction in 1958 of the 332 CID "big block" Ford FE engine which ultimately grew to 428 cu in
Ads
related to: 5.7 sbc rods stroker clearance kit for sale ford