Search results
Results from the WOW.Com Content Network
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
The aspect ratio of an image is the ratio of its width to its height. It is expressed as two numbers separated by a colon, width:height. Common aspect ratios are 1.85:1 and 2.40:1 in cinematography, 4:3 and 16:9 in television, and 3:2 in still photography.
The 120 film format is a roll film which is nominally between 60.7 mm and 61.7 mm wide. Most modern films made today are roughly 61 mm (2.4 inches) wide. The film is held in an open spool originally made of wood with metal flanges, later with all-metal, and finally with all-plastic. The length of the film is nominally between 820 millimetres ...
Anamorphic format is the cinematography technique of shooting a widescreen picture on standard 35 mm film or other visual recording media with a non-widescreen native aspect ratio. It also refers to the projection format in which a distorted image is "stretched" by an anamorphic projection lens to recreate the original aspect ratio on the ...
Ultrawide formats refers to photos, videos, [ 1] and displays [ 2] with aspect ratios greater than 2. There were multiple moves in history towards wider formats, including one by Disney, [ 3] with some of them being more successful than others. Cameras usually capture ultra-wide photos and videos using an anamorphic format lens, which shrinks ...
A fraction is applied to the output unit (if there is only one), or to non-SI units (if using a combination), except that if a precision is also specified, the fraction only applies to the hand unit. {{convert|18.45|in|m|frac=2}} → 18.45 inches ( 1 ⁄ 2 m)
35 mm equivalent focal lengths are calculated by multiplying the actual focal length of the lens by the crop factor of the sensor. Typical crop factors are 1.26× – 1.29× for Canon (1.35× for Sigma "H") APS-H format, 1.5× for Nikon APS-C ("DX") format (also used by Sony, Pentax, Fuji, Samsung and others), 1.6× for Canon APS-C format, 2× for Micro Four Thirds format, 2.7× for 1-inch ...
The first commonly available increase in tape length resulted from a reduction in backing thickness from 1.5 to 1.0 mil (38 to 25 μm) resulting in a total thickness reduction from 42 to 35 μm (1.7 to 1.4 mils), which allowed 3,600 ft (1,100 m), 1,800 ft (550 m), and 900 ft (270 m) tapes to fit on ten-and-a-half-, seven-, and five-inch reels respectively.