Search results
Results from the WOW.Com Content Network
Although the word "trigger" technically implies the entire mechanism (known as the trigger group), colloquially it is usually used to refer specifically to the trigger blade. Most firearm triggers are "single-action", meaning that the trigger is designed only for the single function of disengaging the sear , which allows for a spring -tensioned ...
A forced reset trigger (or "hard reset" trigger) is a device that allows a person to fire a semi-automatic firearm at an increased rate. The forced reset trigger works by mechanically resetting the trigger's position after a shot is fired. This allows for an increased rate of fire.
A binary trigger (or pull and release trigger) is a type of device that allows a semi-automatic firearm to fire at an increased rate. A binary trigger works by firing one shot upon pulling the trigger and then firing a subsequent shot upon release of the trigger. Binary triggers are installed through modification of the fire-control group.
Sear shown in a revolver action. In a firearm, the sear is the part of the trigger mechanism that holds the hammer, striker, or bolt back until the correct amount of pressure has been applied to the trigger, at which point the hammer, striker, or bolt is released to discharge the weapon.
A trigger disconnector captures the hammer in the cocked position after a shot has been fired, even if the trigger is held to the rear as the gun cycles. This ensures the gun can only fire in the semi-automatic mode, as the trigger needs to be released to 'reset' and have the disconnector release the hammer back to the trigger sear.
A diagram from the maintenance manual for installation of Sopwith-Kauper synchronization (Mk.III) gear in early production Sopwith Camels (1917) The first mechanical synchronization gears fitted to early Sopwith fighters were so unsatisfactory that in mid 1916 Sopwiths had an improved gear designed by their foreman of works Harry Kauper , a ...
Straight-pull rifles differ from conventional bolt action mechanisms in that the manipulation required from the user in order to chamber and extract a cartridge predominantly consists of a linear motion only, as opposed to a traditional turn-bolt action where the user has to manually rotate the bolt for chambering and primary extraction.
The type of threads used vary between firearms. European firearms often use either M6 1 or M8 1.25 threads, for example M6 is used on the SIG Sauer 200 STR, Blaser R93, Blaser R8, CZ 457 [30] and Bergara rifles, [30] while M8 is used on the Sako TRG and SIG Sauer 404. Many American firearms instead use 1/4" 28 TPI (6.35 0.907 mm) or 5/16" 24 ...