Search results
Results from the WOW.Com Content Network
PPPoE is used to connect a PC or a router to a modem via an Ethernet link and it can also be used in Internet access over DSL on a telephone line in the PPPoE over ATM (PPPoEoA) over ADSL protocol stack. PPPoE over ATM has the highest overhead of the popular DSL delivery methods, when compared with for example PPPoA (RFC 2364). [11] [12] [13] [14]
If it is used as the connection encapsulation method on an ATM based network it can reduce overhead significantly compared with PPPoEoA – by between 0 and ~3.125% for long packets, depending on the packet length and also on the choices of header options in PPPoEoA – see PPPoEoA protocol overheads.
RFC 2364 describes Point-to-Point Protocol over ATM (PPPoA) as a method for transmitting PPP over ATM Adaptation Layer 5 , which is also a common alternative to PPPoE used with DSL. PPP, PPPoE and PPPoA are widely used in WAN lines. PPP is a layered protocol that has three components: [4]
While it has initially been used to manage only dial-up access, it is also used to manage broadband connections such as DSL, if Point-to-Point Protocol over Ethernet (PPPoE) or Point-to-Point Protocol over ATM (PPPoA) is used. The role of pppd is managing PPP session establishment and session termination.
The service being carried over the "wire" may be Asynchronous Transfer Mode (ATM), Frame Relay, Ethernet or time-division multiplexing (TDM) while the packet network may be Multiprotocol Label Switching (MPLS), Internet Protocol (IPv4 or IPv6), or Layer 2 Tunneling Protocol Version 3 (L2TPv3).
Point-to-point wiring is not suitable for automated assembly (though see wire wrap, a similar method that is) and is carried out manually, making it both more expensive and more susceptible to wiring errors than PCBs, as connections are determined by the person doing assembly rather than by an etched circuit board.
That value was chosen because the maximum length of the data field of an Ethernet 802.3 frame is 1500 bytes and 1536 is equivalent to the number 600 in the hexadecimal numeral system. Thus, values of 1500 and below for this field indicate that the field is used as the size of the payload of the Ethernet frame while values of 1536 and above ...
2 PPPoA - PPPoE Overhead Percentage Difference. 1 comment. 3 Cisco Router example. 1 comment. 4 PPPoA in Australia. ... Talk: Point-to-Point Protocol over ATM. Add ...