Ad
related to: 3.55 vs 3.31 axle ratioebay.com has been visited by 1M+ users in the past month
- Under $10
Fun Stuff. Ships Free.
Brand New. Guilt Free.
- Daily Deals
Lowest Prices on Top Items.
Save Money with eBay Deals.
- Under $10
Search results
Results from the WOW.Com Content Network
35 Spline axle shafts with a 1.5 in (38 mm) diameter; Ratios 3.08 to 4.30. Current production ratios offered are 3.31, 3.55, 3.73, and 4.30. Since ca. 2005, the gears are formed by the face hob process, formerly face milled process.
Dana 35c is a newer version of Dana35. C stands for a Custom as the axle was delivered to the end user without axle brackets. The axle uses a C clip, which holds the axle shafts in the carrier. A centre pin locks the shafts in. Gear Ratio: 3.55 || 11:39 - 4.11 || 9:37 -
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.
Complementing the transmission's gear ratio changes is a new, more aggressive 3.55:1 ratio rear axle which replaces the 3.31:1 axle used previously. According to Inside Line, drivers of the new 2010 Shelby can expect 0 to 60 mph (97 km/h) times in 4.3 seconds from a stand still and 4 seconds flat with roll out.
The Ford 8.8 is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1983 Ford trucks. The axle was developed to replace the Ford 9-inch axle. This axle is still in production today for a variety of Ford vehicles.
The 6R is a 6-speed automatic transmission for longitudinal engine placement in rear-wheel drive vehicles. It is based on the ZF 6HP26 transmission [1] and has been built under license by the Ford Motor Company at its Livonia Transmission plant in Livonia, Michigan.
The Pontiac GTO is a front-engine, rear-drive, two-door, and four-passenger automobile manufactured and marketed by the Pontiac division of General Motors over four generations from 1963 until 1974 in the United States — with a fifth generation made by GM's Australian subsidiary, Holden, for the 2004 through 2006 model years.
However, the 10.5" 14-bolt axle remains in production today, specifically utilized in GMC Savana and Chevrolet Express vans. Notably, the 11.5" 14-bolt axle is featured in third-generation Dodge Ram 2500 and 3500 trucks. There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs.
Ad
related to: 3.55 vs 3.31 axle ratioebay.com has been visited by 1M+ users in the past month