Ad
related to: 3.55 axle ratio towing capacity chart
Search results
Results from the WOW.Com Content Network
Ford used an aluminum matrix composite driveshaft for the 1999–2001 CVPIs as a measure to allow safe operation at high speeds with the 3.55:1 gear ratio, but it was more expensive than the regular aluminum driveshafts and was eliminated with the 3.55:1 rear axle midway through the 2001 model year.
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep
A 2.73 rear-axle ratio was paired with single-exhaust engines; a numerically higher rear-axle ratio was used as part of the handling package. For 2000 and early 2001, a 3.55 rear axle was used; other versions used a 3.27 rear axle.
From 1999 to 2000, the rear axle ratio was 3.55:1, shortened to 3.73:1 in 2001. The same year, a 4.5-inch (110 mm) aluminum driveshaft replaced a 3.5-inch (89 mm) steel unit. [citation needed] Following the 2001 drivetrain revisions, Car and Driver magazine tested a Lightning, accelerating from 0–60 mph (97 km/h) in 5.2 seconds.
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.
It had a 102 in (2,591 mm) wheelbase. The engine was a 235 cu in (3.85 L) inline six engine [15] [2] that was similar to the 235 engine that powered all other Chevrolet car models, but with a higher-compression ratio, three Carter side-draft carburetors, mechanical lifters, and a higher-lift camshaft. Output was 150 hp (112 kW).
The live axle configuration offers advantages in off-road capability and performance at the expense of some on-road comfort and driveability. Mid-1985 and later two-wheel drive models used the same suspension and steering mechanisms with a single tube connecting axle ends, which also meant no transfer case, no front driveshaft, and no front ...
Ad
related to: 3.55 axle ratio towing capacity chart