enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Retaining ring - Wikipedia

   en.wikipedia.org/wiki/Retaining_ring

   Axially assembled retaining rings are installed into machined grooves in housings/bores (internal) or on shafts (external). These rings are manufactured with lug holes—small holes in the lugs of both axial internal and external retaining rings—that are used to install/remove them, using pliers designed for this purpose.

3. Circlip - Wikipedia

   en.wikipedia.org/wiki/Circlip

   A circlip (a portmanteau of "circle" and "clip"), also known as a C-clip, snap ring, or ', [1] is a type of fastener or retaining ring that consists of a semi-flexible metal ring with open ends that can be snapped into place into a machined groove on a dowel pin or other part to permit rotation but to prevent axial movement.

4. Plug (jewellery) - Wikipedia

   en.wikipedia.org/wiki/Plug_(jewellery)

   No o-rings are needed to keep the plug in the piercing, but the fistula needs to be wide enough to accommodate the flare when the plug is initially put in. A single flared plug has one flared end, usually worn on the front of the piercing, and one end with no flare. The no flare end is held in place by an o-ring and may or may not be grooved.

5. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   The RJ45S jack mates with a keyed 8P2C modular plug, [18] [19] and has pins 4 and 5 (the middle positions) wired for the ring and tip conductors of a single telephone line and pins 7 and 8 shorting a programming resistor. This is a different mechanical interface and wiring scheme than ANSI/TIA-568 T568A and T568B schemes with the 8P8C connector ...

6. Core plug - Wikipedia

   en.wikipedia.org/wiki/Core_plug

   The Welch plug is a type of core plug that is made from a thin disc of metal. The Welch plug is dome-shaped and inserted into the casting hole with the convex side facing outwards. [6] When installed by striking the Welch plug with a hammer, the dome collapses slightly, expanding it laterally to seal the hole.

7. DIN connector - Wikipedia

   en.wikipedia.org/wiki/DIN_connector

   Five-pin male 180° DIN connector from a 1988 Schneider MF2 keyboard by Cherry. The DIN connector is an electrical signal connector that was standardized by the Deutsches Institut für Normung (DIN), the German Institute for Standards, in the mid 1950s, initially with 3 pins for mono, but when stereo connections and gear appeared in late 1950s (1959 or so), versions with 5 pins or more were ...