enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. LED tube - Wikipedia

   en.wikipedia.org/wiki/LED_tube

   Retro-fit LED tubes (installation method 1 above) can also often be installed in fixtures designed for LED tubes. In these cases, the fixture typically only acts as a frame or holder to the tube, and electricity supply to the tubes uses the conductors in the fixture. The LED tube may also be compliant with standard EN 62776. LED tubes that are ...

3. T5 retrofit conversion - Wikipedia

   en.wikipedia.org/wiki/T5_retrofit_conversion

   T5 retrofit conversion can maintain existing lighting levels with the higher efficiency of the T5 lamp. However, with kits that operates the lamp on the existing magnetic ballast, the efficiency drops and the lamp life is considerably shortened, as T5 lamps aren't designed to be operated on mains frequency but only on high frequency.

4. Fluorescent-lamp formats - Wikipedia

   en.wikipedia.org/wiki/Fluorescent-lamp_formats

   Retrofit replacement for 45.8 in T5HO 54 W T8 1.0, 25 4 25 F32T8/25w Retrofit replacement for 4 ft T8 32 W T8 1.0, 25 4 28 F28T8 F32T8/28w Retrofit replacement for 4 ft T8 32 W T8 1.0, 25 4 30 F32T8/ES Retrofit replacement for 4 ft T8 32 W T8: 1.0, 25: 2: 17 F17T8: Ballast-swap replacement for 2 ft T12 20 W T8 1.0, 25 3 25 F25T8

5. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

6. Fluorescent lamp - Wikipedia

   en.wikipedia.org/wiki/Fluorescent_lamp

   Overdriving a fluorescent lamp is a method of getting more light from each tube than is obtained under rated conditions. ODNO (Overdriven Normal Output) fluorescent tubes are generally used when there is not enough room to put in more bulbs to increase the light. The method is effective, but generates some additional issues.

7. Electrical ballast - Wikipedia

   en.wikipedia.org/wiki/Electrical_ballast

   A commonly used light in the home in the 1960s in 220–240 V countries was a circular tube ballasted by an under-run regular mains filament lamp. Self ballasted mercury-vapor lamps incorporate ordinary tungsten filaments within the overall envelope of the lamp to act as the ballast, and to partially compensate for the red-deficient light ...