Search results
Results from the WOW.Com Content Network
On SCSI hard disk drives, the SCSI controller can directly control spin up and spin down of the drives. Some Parallel ATA (PATA) and Serial ATA (SATA) hard disk drives support power-up in standby (PUIS): each drive does not spin up until the controller or system BIOS issues a specific command to do so. This allows the system to be set up to ...
A model, called Concurrent-AMAT (C-AMAT), is introduced for more accurate analysis of current memory systems. More information on C-AMAT can be found in the external links section. AMAT's three parameters hit time (or hit latency), miss rate, and miss penalty provide a quick analysis of memory systems. Hit latency (H) is the time to hit in the ...
In fact, even for the Macintosh 512K to use the drive, it requires an additional file in the System Folder on a special startup disk which adds additional code into memory during startup. A startup routine also allows the Mac to check for the presence of a System file on the Hard Disk, switch over to it and eject the startup disk.
Memory latency is the time (the latency) between initiating a request for a byte or word in memory until it is retrieved by a processor. If the data are not in the processor's cache , it takes longer to obtain them, as the processor will have to communicate with the external memory cells.
Access time is the time delay or latency between a request to an electronic system, and the access being initiated or the requested data returned.. In computer and software systems, it is the time interval between the point where an instruction control unit initiates a call to retrieve data or a request to store data, and the point at which delivery of the data is completed or the storage is ...
It is for this reason that DDR3-2666 CL9 has a smaller absolute CAS latency than DDR3-2000 CL7 memory. Both for DDR3 and DDR4, the four timings described earlier are not the only relevant timings and give a very short overview of the performance of memory. The full memory timings of a memory module are stored inside of a module's SPD chip.
The drive circuitry usually has a small amount of memory, used to store the data going to and coming from the disk platters. The disk buffer is physically distinct from and is used differently from the page cache typically kept by the operating system in the computer's main memory. The disk buffer is controlled by the microcontroller in the ...
By reducing the I/O activity caused by paging requests, virtual memory compression can produce overall performance improvements. The degree of performance improvement depends on a variety of factors, including the availability of any compression co-processors, spare bandwidth on the CPU, speed of the I/O channel, speed of the physical memory, and the compressibility of the physical memory ...