enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Soldering station - Wikipedia

   en.wikipedia.org/wiki/Soldering_station

   A soldering station is a multipurpose power soldering device designed for electronic components soldering. This type of equipment is mostly used in electronics and electrical engineering . Soldering station consists of one or more soldering tools connected to the main unit, which includes the controls (temperature adjustment), means of ...

3. Soldering gun - Wikipedia

   en.wikipedia.org/wiki/Soldering_gun

   A 1948 advertisement for a Weller soldering gun. Pistol-grip electrically-heated soldering tools had been used since the 1920s. In 1941 Carl E. Weller invented and later obtained U.S. patent 2,405,866 [1] for a transformer-based soldering tool which heated and cooled rapidly, [2] essentially as described in this article.

4. Soldering iron - Wikipedia

   en.wikipedia.org/wiki/Soldering_iron

   Spool of solder. 1.6mm. When the iron tip oxidises and burnt flux accumulates on it, solder no longer wets the tip, impeding heat transfer and making soldering difficult or impossible; tips must be periodically cleaned in use. Such problems happen with all kinds of solder, but are much more severe with the lead-free solders which have become ...

5. Desoldering - Wikipedia

   en.wikipedia.org/wiki/Desoldering

   A technique sometimes used is the use of a large soldering-iron tip designed to melt the solder on all pins at once; different tips are required for different packages. The component is removed while the solder is molten, most easily by a spring-loaded puller attached to it before heating.

6. Soldering - Wikipedia

   en.wikipedia.org/wiki/Soldering

   The tip of the bit (commonly iron plated to reduce erosion) is kept wetted with solder ("tinned") when hot to assist soldering, and to minimize oxidation and corrosion of the tip itself. After inserting a through-hole mounted component, the excess lead is cut off, leaving a length of about the radius of the pad.

7. Solderability - Wikipedia

   en.wikipedia.org/wiki/Solderability

   Both quantitative and qualitative tests for solderability exist. [6] The two most common testing methods are the 'dip and look' method and wetting balance analysis.In both of these tests, the soldered pieces undergo an accelerated aging process before being tested for solderability, to take into consideration the time a component was in storage prior to mounting to final assembly.