Search results
Results from the WOW.Com Content Network
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
All C-V8s used big-block engines sourced from Chrysler; first the 361 and then, from 1964, the 330 bhp (246 kW) 383 in³. Most of the cars had three-speed Chrysler Torqueflite automatic transmission, but seven Mk2 C-V8s were produced with the 6-litre engine and four-speed manual gearbox, followed by two manual Mk3s. The engine is entirely set ...
Jensen Motors used Chrysler V8 engines for the Interceptor, starting with the 6,276 cc (383 c.i.) with optional manual (Mark I, 22 built) or TorqueFlite automatic transmissions driving the rear wheels through a limited slip differential in a conventional Salisbury rear axle. In 1970, the 383 c.i. produced 335 hp SAE gross, or 270 hp SAE net.
Chrysler used a 14 mm (0.55 in) spark plug, rather than the typical 18 mm (0.71 in), in an effort to fit it as centrally as possible in the combustion chamber. [ 1 ] The intake and exhaust valves were the same size as the 426's, [ 6 ] the 2.25 in (57 mm) intake canted at 15° from the bore centerline, the 1.94 in (49 mm) exhaust at 6°. [ 6 ]
In 1966, the Coronet Deluxe was introduced, fitting between the base Coronet and the Coronet 440. The Coronet R/T was introduced in 1967. The Coronet R/T was available as a two-door hardtop or convertible. The standard engine was Chrysler's largest, the 440 cu in (7.2 L) V8 producing 375 bhp and dubbed the Magnum.
All Newport models including wagons had a larger standard engine for 1965: The 3.375 inch stroke LB engine was bored to 4.25 inches yielding 383 cubic inches. With a 2BBL carburetor and single exhaust, the regular fuel 383 produced 270 HP. A premium fuel 383 engine with 4BBL and dual exhausts producing 305 HP was an available option.
The standard-equipment engine on the 1969 Monaco is Chrysler's 245-horsepower (183 kW) B-block 383 cu in (6.3 L) V8 engine with a two-barrel 2245 Holley carburetor. Buyers could order the 383 with a four-barrel carburetor that increased power to 330 hp (250 kW), or they could opt for the 375-horsepower (280 kW) 440 cu in (7.2 L) Magnum RB-block ...
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.