Search results
Results from the WOW.Com Content Network
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
The F connector is an inexpensive, gendered, threaded, compression connector for radio frequency signals. It has good 75 Ω impedance match for frequencies well over 1 GHz [2] and has usable bandwidth up to several GHz. Connectors mate using a 3/8-32UNEF thread. The female connector has a socket for the center conductor and external threads.
Fischer Connectors’s main production site in Saint-Prex, Switzerland (2013) Fischer Connectors is a Swiss multinational company that designs, manufactures and distributes electrical connectors and optical fiber connectors, cable assemblies and electronic and connectivity systems.
Twist-on wire connectors are not generally recommended for use with aluminum wire in the United States. [1] The U.S. Consumer Product Safety Commission disapproves wire nuts for aluminum wire; instead, special crimp connectors are called for, and as of 2011 the CPSC asserted qualified, second-preference approval of a certain kind of screw ...
The flange design, inner and outer conductor dimensions are standardized, by EIA, in the RS-225, 50 Ω (ohm), and RS-259, 75 Ω, standards.They are commonly referred to by the inner diameter of the outer conductor in fractional inches.
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect