Search results
Results from the WOW.Com Content Network
On-Demand Routing ("ODR") is an enhancement to Cisco Discovery Protocol (CDP), a protocol used to discover other Cisco devices on either broadcast or non-broadcast media. With the help of CDP, it is possible to find the device type, the IP address, the Cisco IOS version running on the neighbor Cisco device, the capabilities of the neighbor device, and so on.
Cisco Discovery Protocol (CDP) is a proprietary data link layer protocol developed by Cisco Systems in 1994 [1] by Keith McCloghrie and Dino Farinacci. It is used to share information about other directly connected Cisco equipment, such as the operating system version and IP address .
CDP was created by Cisco in 1994. [2] Its original intent was to make it easier to find other devices on a network. [1] CDP may be used between Cisco routers, switches and other network equipment to advertise their software version, capabilities and IP address. [3] The two versions of CDP are CDPv1 and CDPv2:
Router1# show ip eigrp topology 10.0.0.1 [13] 255.255.255.255 IP-EIGRP topology entry for 10.0.0.1/32 State is Passive, Query origin flag is 1, 1 Successor(s), FD is 40640000 Routing Descriptor Blocks: 10.0.0.1 (Serial0/0/0), from 10.0.0.1, Send flag is 0x0 Composite metric is (40640000/128256), Route is Internal Vector metric: Minimum ...
The primary function of a router is to forward a packet toward its destination network, which is the destination IP address of the packet. To do this, a router needs to search the routing information stored in its routing table. The routing table contains network/next hop associations. These associations tell a router that a particular ...
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
The Secure Neighbor Discovery (SEND) protocol is a security extension of the Neighbor Discovery Protocol (NDP) in IPv6 defined in RFC 3971 and updated by RFC 6494.. The Neighbor Discovery Protocol (NDP) is responsible in IPv6 for discovery of other network nodes on the local link, to determine the link layer addresses of other nodes, and to find available routers, and maintain reachability ...