enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 0-10 V lighting control - Wikipedia

   en.wikipedia.org/wiki/0-10_V_lighting_control

   Dimming fluorescent ballasts and dimming LED drivers often use 0–10 V control signals to control dimming functions. In many cases, the dimming range of the power supply or ballast is limited. If the light output can only be dimmed from 100% down to 10%, there must be a switch or relay available to kill power to the system and turn the light ...

3. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.

4. 3-way lamp - Wikipedia

   en.wikipedia.org/wiki/3-way_lamp

   The contacts of a 3-way bulb Circuit diagram of a 3-way bulb. A 3-way incandescent bulb has two filaments designed to produce different amounts of light. The two filaments can be activated separately or together, giving three different amounts of light. One common 3-way incandescent bulb is the 50/100/150 W.

5. Dimmer - Wikipedia

   en.wikipedia.org/wiki/Dimmer

   Dimmer in a residential application with RF-based remote control. Non domestic dimmers are usually controlled remotely by means of various protocols. Analogue dimmers usually require a separate wire for each channel of dimming carrying a voltage between 0 and 10 V. Some analogue circuitry then derives a control signal from this and the mains ...

6. Electrical ballast - Wikipedia

   en.wikipedia.org/wiki/Electrical_ballast

   A dimmable ballast is very similar to a rapid start ballast, except that the autotransformer is connected to a dimmer. A quadrac type light dimmer can be used with a dimming ballast, which maintains the heating current while allowing lamp current to be controlled. A resistor of about 10 kΩ is required to be connected in parallel with the ...

7. Digital Addressable Lighting Interface - Wikipedia

   en.wikipedia.org/wiki/Digital_Addressable...

   Digital Addressable Lighting Interface (DALI) is a trademark for network-based products that control lighting.The underlying technology was established by a consortium of lighting equipment manufacturers as a successor for 1-10 V/ 0–10 V lighting control systems, and as an open standard alternative to several proprietary protocols.

8. Light-emitting diode - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode

   Very small (1.6×1.6×0.35 mm) red, green, and blue surface mount miniature LED package with gold wire bonding details. These are mostly single-die LEDs used as indicators, and they come in various sizes from 1.8 mm to 10 mm, through-hole and surface mount packages. [47] Typical current ratings range from around 1 mA to above 20 mA.

9. Wiring diagram - Wikipedia

   en.wikipedia.org/wiki/Wiring_diagram

   An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...