Search results
Results from the WOW.Com Content Network
The peak-to-peak value is used, for example, when choosing rectifiers for power supplies, or when estimating the maximum voltage that insulation must withstand. Some common voltmeters are calibrated for RMS amplitude, but respond to the average value of a rectified waveform. Many digital voltmeters and all moving coil meters are in this category.
Peak values can be calculated from RMS values from the above formula, which implies V P = V RMS × √ 2, assuming the source is a pure sine wave. Thus the peak value of the mains voltage in the USA is about 120 × √ 2, or about 170 volts. The peak-to-peak voltage, being double this, is about 340 volts.
The peak-to-average power ratio (PAPR) is the peak amplitude squared (giving the peak power) divided by the RMS value squared (giving the average power). [1] It is the square of the crest factor. When expressed in decibels , crest factor and PAPR are equivalent, due to the way decibels are calculated for power ratios vs amplitude ratios .
The processing quality of 12-bit images is considered high when the PSNR value is 60 dB or higher. [3] [4] For 16-bit data typical values for the PSNR are between 60 and 80 dB. [5] [6] Acceptable values for wireless transmission quality loss are considered to be about 20 dB to 25 dB. [7] [8]
Assuming a full-scale sine wave signal (that is, the quantizer is designed such that it has the same minimum and maximum values as the input signal), the quantization noise approximates a sawtooth wave with peak-to-peak amplitude of one quantization level [11] and uniform distribution. In this case, the SNR is approximately
Various properties of ripple voltage may be important depending on application: the equation of the ripple for Fourier analysis to determine the constituent harmonics; the peak (usually peak-to-peak) value of the voltage; the root mean square (RMS) value of the voltage which is a component of power transmitted; the ripple factor γ, the ratio ...
A potential for ambiguity exists when assigning a level on the dBFS scale to a waveform rather than to a specific amplitude, because some engineers follow the mathematical definition of RMS, which for sinusoidal signals is 3 dB below the peak value, while others choose the reference level so that RMS and peak measurements of a sine wave produce ...
Peak-to-trough ratio in pharmacokinetics is the ratio of peak (C max) and trough (C min) levels of a drug over its dosing interval (τ) at steady state.. Peak-to-trough ratio (PTR), also known as peak-to-trough variation or peak-to-trough fluctuation, is a parameter in pharmacokinetics which is defined as the ratio of C max (peak) concentration and C min (trough) concentration over a dosing ...