enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pentel - Wikipedia

   en.wikipedia.org/wiki/Pentel

   Product lines include Sharp Kerry, Sharp P200 series, Graph 1000, Graphgear (500, 800 and 1000), Smash, Orenz, OrenzNero (mechanical pencils or "sharps"); Ain and Hi-Polymer (mechanical pencil leads, erasers); Energel (gel ink pens); Vicuña (hybrid ink ballpoint pen); Pentel Pen (permanent marker), and Sign Pen (fine tip marker).

3. Technical pen - Wikipedia

   en.wikipedia.org/wiki/Technical_pen

   Text (produced by an ISO stencil template for use with the technical pens) of 5 mm in height has a stroke or line thickness of 0.5 mm, and so requires a brown-nibbed 0.5 mm pen. If this text were used in an ISO-sized document (e.g. A0), and the document were reproduced at half its original height (A2), the text would be rendered 2.5 mm high ...

4. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

5. ISO 965 - Wikipedia

   en.wikipedia.org/wiki/ISO_965

   ISO 965 (ISO general purpose metric screw thread—tolerances) is an International Organization for Standardization (ISO) standard for metric screw thread tolerances. [1] It specifies the basic profile for ISO general purpose metric screw threads (M) conforming to ISO 261. [2] The tolerance system refers to the basic profile in accordance with ...

6. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

7. Blade solidity - Wikipedia

   en.wikipedia.org/wiki/Blade_solidity

   is ratio of hub to tip diameter; is the specific speed; Cordier diagram can be used to determine specific speed and impeller tip diameter . Accordingly solidity ratio and hub-tip ratio (range 0.3-0.7) can be adjusted.