Ads
related to: slotted bead size and jig hook size chart
Search results
Results from the WOW.Com Content Network
They have a hole drilled through the center of the bead and are applied onto the hook and pushed up to behind the eye. Slotted holes are also available for jig head hooks. Beads are sized to the hook and come in diameters of 1/16 (#18-#22), 5/64 (#16-#20), 3/32 (#14-#18), 7/64 (#12-#16), 1/8 (#10-#14), 5/32 (#8-#12), and 3/16 (#6-#10) inches.
They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw.
In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...
Early hooks were made from the upper bills of eagles and from bones, shells, horns and thorns of plants (Parker 2002). In 2005, the fish hook was chosen by Forbes as one of the top twenty tools in the history of man. [2] Fish hooks are normally attached to some form of line or lure device which connects the caught fish to the angler. There is ...
Ads
related to: slotted bead size and jig hook size chart