Search results
Results from the WOW.Com Content Network
DTMF was known throughout the Bell System by the trademark Touch-Tone. The term was first used by AT&T in commerce on July 5, 1960, and was introduced to the public on November 18, 1963, when the first push-button telephone was made available to the public.
Multifrequency signaling is a technological precursor of dual-tone multi-frequency signaling (DTMF, Touch-Tone), which uses the same fundamental principle, but was used primarily for signaling address information and control signals from a user's telephone to the wire-center's Class-5 switch. DTMF uses a total of eight frequencies.
Pressing a single key of a traditional analog telephone keypad produces a telephony signaling event to the remote switching system. For touchtone service, the signal is a dual-tone multi-frequency signaling tone consisting of two simultaneous pure tone sinusoidal frequencies. The row in which the key appears determines the low-frequency ...
The Concrete, Washington area has a system of eight 8032B Modulators to warn of possible breaches at the Baker River Dam. The system uses a distinctive "WHOOP" tone that was originally produced for Federal Signal's line of fire alarms. The system is tested on the second Monday of every month at 6:00pm. [6]
Some decoders may require much longer-duration digits. DTMF digits consist of paired tones: a row tone and a column tone. The levels of row and column tones must be similar in order for a decoder to interpret them reliably. Radios with DTMF decoders may monitor all system traffic or remain muted until called, depending on the system design.
Some central office switches in the United States, notably older GTD-5 EAX systems, utilize a single frequency tone, 480 Hz, known as High Tone for this purpose. In either case, the tone is substantially louder than any other signal transmitted over a copper POTS circuit; loud enough to be heard across a room from an unused off-hook telephone.
By the 1940s they had developed a system that used audible tones played over the long-distance lines to control network connections. Tone pairs, referred to as multi-frequency (MF) signals, were assigned to the digits used for telephone numbers. A different, single tone, referred to as single frequency (SF), was used as a line status signal.
Symbols in the DTMF and MF alphabets are sent as tone pairs; DTMF selects one tone from a "high" group and one from a "low" group, while MF selects its two tones from a common set. DTMF and MF use different tone frequencies largely to keep end users from interfering with inter-office signaling.