Search results
Results from the WOW.Com Content Network
A kinetic energy recovery system (KERS) is an automotive system for recovering a moving vehicle's kinetic energy under braking. The recovered energy is stored in a reservoir (for example a flywheel or high voltage batteries) for later use under acceleration.
An assumption is made that during braking there is no change in the potential energy, enthalpy of the flywheel, pressure or volume of the flywheel, so only kinetic energy will be considered. As the car is braking, no energy is dispersed by the flywheel, and the only energy into the flywheel is the initial kinetic energy of the car.
A smart battery requires a smart charger. Some smart chargers can also charge "dumb" batteries, which lack any internal electronics. The output current of a smart charger depends upon the battery's state. An intelligent charger may monitor the battery's voltage, temperature or charge time to determine the optimum charge current or terminate ...
A portable power bank charging a mobile phone. A power bank is a portable device consisting of a battery, a charger to interface battery with charging power source and an output interface to provide desired output voltage. [10] Power banks are made in various sizes and typically based on lithium-ion batteries. A power bank contains battery ...
A rechargeable battery bank used in a data center Lithium iron phosphate battery modules packaged in shipping containers installed at Beech Ridge Energy Storage System in West Virginia [9] [10] Battery storage power plants and uninterruptible power supplies (UPS) are comparable in technology and function. However, battery storage power plants ...
A charge cycle is the process of charging a rechargeable battery and discharging it as required into a load.The term is typically used to specify a battery's expected life, as the number of charge cycles affects life more than the mere passage of time.
A shunt charge controller or shunt regulator diverts excess electricity to an auxiliary or "shunt" load, such as an electric water heater, when batteries are full. [7] Simple charge controllers stop charging a battery when they exceed a set high voltage level, and re-enable charging when battery voltage drops back below that level.
In practice, it depends on the capability of the charger. The battery capacity C is expressed in Ah units, typically the C 20 value based on a 20-hour discharge time. [3] The charging current (in A units) can be written as C/t where t is a time. For example, for a battery with C = 40 Ah, a current C/10 is equal to 4 A. The charging current is a ...