Search results
Results from the WOW.Com Content Network
A right-hand railroad switch with point indicator pointing to right Animated diagram of a right-hand railroad switch. Rail track A divides into two: track B (the straight track) and track C (the diverging track); note that the green line represents direction of travel only, the black lines represent fixed portions of track, and the red lines depict the moving components.
The point machine (in this case an electric motor) and associated mechanism used to operate this switch can be seen to the right in the picture. A point machine (also known as a point motor, switch machine or switch motor) is a device for operating railway turnouts especially at a distance.
Turnouts facing and trailing. Note that this diagram is for left-hand traffic; for right-hand traffic, "F" and "T" would be swapped. Facing or trailing are railway turnouts (or 'points' in the UK) in respect to whether they are divergent or convergent. When a train traverses a turnout in a facing direction, it may diverge onto either of the two ...
Limited Speed - A speed less than Normal Speed that was employed starting in the 1940s for use with higher speed turnouts (switches). This speed is defined by individual railroads and ranges anywhere from 40 miles per hour (64 km/h) to 60 miles per hour (97 km/h).
Electric locking "The combination of one or more electric locks or controlling circuits by means of which levers in an interlocking machine, or switches or other devices operated in connection with signalling and interlocking, are secured against operation under certain conditions." [19] Section locking
The locomotive decoders are dependent on AC track power (50 or 60 Hz) to synchronize the command receiver. Thus, TMCC can only operate on AC track power. Because TMCC utilizes the DCC command codes, it is possible to control TMCC with DCC compatible software. MTH Electric Trains included support to interface and control TMCC with its DCS system.
The majority of these were commissioned before 1970, a few of which have been in continuous use since the late nineteenth century, albeit surviving in a modified state. Eleven are still fitted with Byles-type mechanical lever frames and five have early relay interlocking with Individual Function Switch (IFS) or similar electric switch panels.
A high-voltage disconnect switch used in an electrical substation. Such switches are used mostly to isolate circuits, and usually cannot break load current. High-voltage switches are available for the highest transmission voltages, up to 1 million volts. This switch is gang-operated so that all three phases are interrupted at the same time.