enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Lumber - Wikipedia

   en.wikipedia.org/wiki/Lumber

   As previously noted, less wood is needed to produce a given finished size than when standards called for the green lumber to be the full nominal dimension. However, even the dimensions for finished lumber of a given nominal size have changed over time. In 1910, a typical finished 1-inch (25 mm) board was 13 ⁄ 16 in (21 mm). In 1928, that was ...

3. Parallel-strand lumber - Wikipedia

   en.wikipedia.org/wiki/Parallel-strand_lumber

   The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...

4. Plank (wood) - Wikipedia

   en.wikipedia.org/wiki/Plank_(wood)

   The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist.

5. Shiplap - Wikipedia

   en.wikipedia.org/wiki/Shiplap

   Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm (3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm (3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [1] The rabbet allows the boards to overlap in this area.

6. Cross-laminated timber - Wikipedia

   en.wikipedia.org/wiki/Cross-laminated_timber

   Likewise, all lumber for the minor direction must have a single set of properties. Higher quality lumber can also be grouped so that it is reserved for areas in which fasteners are installed to maximize fastener effectiveness. For aesthetic purposes, some lumber will be set aside so that the outermost layer of a panel is visually appealing. [1]

7. Frame and panel - Wikipedia

   en.wikipedia.org/wiki/Frame_and_panel

   Panels are made slightly smaller than the available space within the frame to provide room for movement. Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door.