Search results
Results from the WOW.Com Content Network
In modern notation we would write, = +, where is the open-circuit emf of the thermocouple, is the internal resistance of the thermocouple and is the resistance of the test wire. In terms of the length of the wire this becomes, I = E r + R ℓ , {\displaystyle I={\frac {\mathcal {E}}{r+{\mathcal {R}}\ell }},} where R {\displaystyle {\mathcal {R ...
When the power source delivers current, the measured voltage output is lower than the no-load voltage; the difference is the voltage drop (the product of current and resistance) caused by the internal resistance. The concept of internal resistance applies to all kinds of electrical sources and is useful for analyzing many types of circuits.
Electrical resistivity (also called volume resistivity or specific electrical resistance) is a fundamental specific property of a material that measures its electrical resistance or how strongly it resists electric current. A low resistivity indicates a material that readily allows electric current.
One is its internal resistance and the other is its compliance voltage. The compliance voltage is the maximum voltage that the current source can supply to a load. Over a given load range, it is possible for some types of real current sources to exhibit nearly infinite internal resistance.
The incremental inductance rule, attributed to Harold Alden Wheeler [1] by Gupta [2]: 101 and others [3]: 80 is a formula used to compute skin effect resistance and internal inductance in parallel transmission lines when the frequency is high enough that the skin effect is fully developed. Wheeler's concept is that the internal inductance of a ...
Internal resistance varies with the age of a battery, but for most commercial batteries the internal resistance is on the order of 1 ohm. When there is a current through a cell, the measured e.m.f. is lower than when there is no current delivered by the cell.
Contact resistance values are typically small (in the microohm to milliohm range). Contact resistance can cause significant voltage drops and heating in circuits with high current. Because contact resistance adds to the intrinsic resistance of the conductors, it can cause significant measurement errors when exact resistance values are needed.
Assuming the element behaves as a perfect resistor and that the power is completely converted into heat, the formula can be re-written by substituting Ohm's law, =, into the generalized power equation: = = = / where R is the resistance.