Search results
Results from the WOW.Com Content Network
Hall effect devices produce a very low signal level and thus require amplification. The vacuum tube amplifier technology available in the first half of the 20th century was too large, expensive, and power-consuming for everyday Hall effect sensor applications, which were limited to laboratory instruments.
16-key encoder three-state 18 MM74C922: 74x923 1 20-key encoder three-state 20 MM74C923: 74x925 1 4-digit counter/display driver 16 MM74C925: 74x926 1 4-digit decade counter/display driver, carry out and latch (up to 9999) 16 MM74C926: 74x927 1 4-digit timer counter/display driver (up to 9599, intended as time elapsed, i.e. 9:59.9 min) 16 ...
The following is a list of CMOS 4000-series digital logic integrated circuits.In 1968, the original 4000-series was introduced by RCA.Although more recent parts are considerably faster, the 4000 devices operate over a wide power supply range (3V to 18V recommended range for "B" series) and are well suited to unregulated battery powered applications and interfacing with sensitive analogue ...
The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with each other, e.g. R17A, R17B. The IEEE 315 standard contains a list of Class Designation Letters to use for electrical and electronic ...
In ferromagnetic materials (and paramagnetic materials in a magnetic field), the Hall resistivity includes an additional contribution, known as the anomalous Hall effect (or the extraordinary Hall effect), which depends directly on the magnetization of the material, and is often much larger than the ordinary Hall effect.
The planar Hall sensor is a type of magnetic sensor based on the planar Hall effect of ferromagnetic materials. [1] [2] It measures the change in anisotropic magnetoresistance caused by an external magnetic field in the Hall geometry. As opposed to an ordinary Hall sensor, which measures field components perpendicular to the sensor plane, the ...
If the face has a part name made up of only one letter and a few numbers, it can be either a Japanese or a Pro Electron part number. Thus, "C1234" would likely be a 2SC1234 device, but "C547" is usually short for "BC547". TO-92 packages with pre-bent wires; on the left to emulate a TO-18 footprint (SO-97 in BS 3934, 10A3 in DIN 41868)
existing instructions extended to a 64 bit operand size (remaining instructions) Most instructions with a 64 bit operand size encode this using a REX.W prefix; in the absence of the REX.W prefix, the corresponding instruction with 32 bit operand size is encoded. This mechanism also applies to most other instructions with 32 bit operand size.