Search results
Results from the WOW.Com Content Network
The STC provides a standardized way to compare products such as doors and windows made by competing manufacturers. A higher number indicates more effective sound insulation than a lower number. The STC is a standardized rating provided by ASTM E413 based on laboratory measurements performed in accordance with ASRM E90. ASTM E413 can also be ...
It is occasionally used to rate floor coverings. [7] NRC is intended to be a simplified acoustical rating of room construction and finish materials when the acoustical objectives of the space are less than sensitive. The NRC average is rounded to the nearest 0.05 due to a typical lab repeatability of ±0.05 for 2 standard deviations.
The OSNR is the ratio between the signal power and the noise power in a given bandwidth. Most commonly a reference bandwidth of 0.1 nm is used. This bandwidth is independent of the modulation format, the frequency and the receiver. For instance an OSNR of 20 dB/0.1 nm could be given, even the signal of 40 GBit DPSK would not fit in this bandwidth.
The mean and the standard deviation of a set of data are descriptive statistics usually reported together. In a certain sense, the standard deviation is a "natural" measure of statistical dispersion if the center of the data is measured about the mean. This is because the standard deviation from the mean is smaller than from any other point.
The "ceiling effect" is one type of scale attenuation effect; [1] the other scale attenuation effect is the "floor effect". The ceiling effect is observed when an independent variable no longer has an effect on a dependent variable, or the level above which variance in an independent variable is no longer measurable. [2]
The article states that STC ratings before 1999 would be unreliable, however the chart of values was taken from a book published in 1994. —Preceding unsigned comment added by 204.128.192.3 ( talk ) 20:58, 30 September 2009 (UTC) [ reply ]
As with the ¯ and R and individuals control charts, the ¯ chart is only valid if the within-sample variability is constant. [5] Thus, the s chart is examined before the x ¯ {\displaystyle {\bar {x}}} chart; if the s chart indicates the sample variability is in statistical control, then the x ¯ {\displaystyle {\bar {x}}} chart is examined to ...
The numbers of older IEC standards were converted in 1997 by adding 60000; for example IEC 27 became IEC 60027. IEC standards often have multiple sub-part documents; only the main title for the standard is listed here. IEC 60027 Letter symbols to be used in electrical technology; IEC 60028 International standard of resistance for copper