Search results
Results from the WOW.Com Content Network
The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units. {{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in ...
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
Template talk:Convert • Questions on using the convert template, or discussion of any problems encountered, or proposals to add units or change convert; Wikipedia:Help desk • General questions; Module talk:Convert • Discussion concerning the convert modules (however, discussions relating to units should occur at Template talk:Convert)
For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...
Different lengths as in respect to the electromagnetic spectrum, measured by the metre and its derived scales.The microwave is between 1 meter to 1 millimeter.. The millimetre (international spelling; SI unit symbol mm) or millimeter (American spelling) is a unit of length in the International System of Units (SI), equal to one thousandth of a metre, which is the SI base unit of length.