Search results
Results from the WOW.Com Content Network
Do-It-Yourself Arduino Uno R3 compatible footprint and connections. Additional features: 5V, 1.5A LDO voltage regulator with heat sink; 3.3V, 250mA LDO voltage regulator; 6 to 35 V DC power supply; LEDs and voltage regulator can be disabled to safe on current; screw terminal block for power supply; ST1 Sanjay Technologies (sanjaytechnologies.co ...
Name License Source model Target uses Status Platforms Apache Mynewt: Apache 2.0: open source: embedded: active: ARM Cortex-M, MIPS32, Microchip PIC32, RISC-V: BeRTOS: Modified GNU GPL: open source
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
In this table the USB 2.0 and 3.0 columns document the number of host ports available on the single-board computer (SBC) that can be used to connect USB devices such as flash drives or cameras to the SBC.
uChip mounted on a breadboard Arduino Zero compatible, with narrow (0.3" row spacing) 16-pin DIP footprint (breadboard compatible). It features built-in buck (to power external circuitry) and boost (to power USB devices when operating as a USB host) converters and software selectable output voltage.
Populated (rear) and unpopulated (front) TSOP land patterns on a printed circuit board. A row of through-holes acting as the footprint for a pin header.. A footprint or land pattern is the arrangement of pads (in surface-mount technology) [1] or through-holes (in through-hole technology) used to physically attach and electrically connect a component to a printed circuit board.
This is a table of 64/32-bit central processing units that implement the ARMv8-A instruction set architecture and mandatory or optional extensions of it. Most chips support the 32-bit ARMv7-A for legacy applications.
NodeMCU DEVKIT 1.0, bottom. NodeMCU is a low-cost open source IoT platform. [4] [5] It initially included firmware which runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which was based on the ESP-12 module.