Search results
Results from the WOW.Com Content Network
Bolt action: A type of firearm action in which the firearm's bolt is operated manually by the opening and closing of the breech with a small handle. As the handle is operated, the bolt is unlocked, the breech is opened, the spent shell casing is withdrawn and ejected, the firing pin is cocked, and a new round/shell (if available) is placed into ...
270 Winchester necked down to a .243 bullet with the angle increased to 35 degrees - The 270 Winchester is a standardized cartridge of the same design as the 30-06 except the case is 1.2mm longer and necked down to the .270 caliber. Therefore, the 243 Catbird is a 6mm-06 with a 35 degree shoulder and a 1.2mm longer case. [10]
Break-action shotguns, double rifles, and combination guns typically have an extractor that pushes out the casings when the action is flexed open. Most modern extractors are forceful enough to completely eject the casing from the gun (i.e. integrating the function of an ejector), but some require the user to manually remove spent cartridges.
Action threads, also called receiver threads, are situated at the chamber end of the barrel, and can be used for attaching the barrel to the receiver. The receiver normally has corresponding threads which are internal, with the matching action threads on the barrel usually being external threads.
The .17 Remington is based on the .223 Remington case necked down to .172 in (4.37 mm), with the shoulder moved back. [5] [6]Extremely high initial velocity (over 4,000 ft/s 1,200 m/s), flat trajectory and very low recoil are the .17 Remington's primary attributes.
It is the parent case for the 6.8mm Remington SPC, [1] which is in turn the parent case for the .224 Valkyrie. The .30 Remington, along with the 25 Remington , .32 Remington. and .35 Remington were created for use in the Remington Model 8 rifle, to compete against the .25-35 Winchester , .30-30 Winchester and .32 Winchester Special .
Most controlled feed mechanisms use a fixed mechanical ejector attached to the receiver, which results in the bolt having to be pulled all or almost all the way back to eject the spent casing. This can give a marginally quicker cyclic rate with a push feed action, since the bolt no longer has to be repeated as far or all the way back. [10]
A telescoping bolt is a bolt that wraps around the breech end of the barrel. This bolt design is often used to reduce overall weapon length without sacrificing barrel length or bolt weight. A turn bolt refers to a firearm component where the whole bolt without using a bolt carrier turns to lock and unlock.