enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Honeywell water heater gas control valve pilot won't stay lit

   diy.stackexchange.com/questions/189013

   This hot water heater will not light. I am able to get the pilot light to light and after a short delay, the indicator light on the control valve LED status light begins to flash normally. At this point, the pilot button should be able to be released and the pilot light remains lit in order to select an operating temperature on the control knob.

3. 6 Reasons Why a Water Heater Pilot Light Won't Stay Lit

   www.doityourself.com/stry/reasons-why-a-water-heater-pilot-light-wont-stay-lit

   Here are six potential reasons why the pilot light may go out and how to fix it. 1. Obstructed Thermocouple. Most water heaters operate with a thermocouple. This device is central to the operation and can tell if the pilot light is on or off by an electrical current that is powered by the pilot’s heat.

4. Pilot in gas water heater still goes out after replacing...

   diy.stackexchange.com/questions/104199

   The last time the hot water was used was at around 8PM on Sunday and it was still working properly. This morning (Monday) the pilot was out again and I relighted it. Edit 2: Tonight, I checked the pilot and it was still lit. However, after 2 people took showers at the same time (which probably cause the burner to kick in), the pilot went out.

5. Pilot Light Still Won’t Stay On after Changing Thermocouple

   www.doityourself.com/stry/pilot-light-still-won-t-stay-on-after-changing...

   If it is a match light type, light the pilot and continue depressing the knob for at least a full minute to allow the thermocouple to warm enough to hold the gas valve open. Slowly release the depressed knob and hope the pilot stays lit. If it does, turn the knob to run or on and the burner should light.

6. I ran out of propane and now the water heater pilot light will...

   diy.stackexchange.com/questions/151425

   Propane water heater won't stay lit Hot Network Questions Example Windows 3.11 286 protected mode program - how long did Win 3.1 286 protected mode last?

7. furnace - Why does my pilot light go out when I release the pilot...

   diy.stackexchange.com/questions/33225

   The button you press to light the pilot bypasses the thermocouple. When you release the button, the thermocouple ensures that unburned gas doesn't get released by shutting off the gas when it's not heated by the burning pilot light.