enow.com Web Search

  1. Ads

    related to: control arm for suspension

Search results

  1. Results from the WOW.Com Content Network
  2. Control arm - Wikipedia

    en.wikipedia.org/wiki/Control_arm

    MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...

  3. Multi-link suspension - Wikipedia

    en.wikipedia.org/wiki/Multi-link_suspension

    A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3][4]

  4. Double wishbone suspension - Wikipedia

    en.wikipedia.org/wiki/Double_wishbone_suspension

    A double wishbone suspension is an independent suspension design for automobiles using two (occasionally parallel) wishbone -shaped arms to locate the wheel. Each wishbone or arm has two mounting points to the chassis and one joint at the knuckle. The shock absorber and coil spring mount to the wishbones to control vertical movement.

  5. Car suspension - Wikipedia

    en.wikipedia.org/wiki/Car_suspension

    Commonly, springs are mounted on control arms, swing arms or some other pivoting suspension member. Consider the example above, where the spring rate was calculated to be 500 lbs/inch (87.5 N/mm), if one were to move the wheel 1 in (2.5 cm) (without moving the car), the spring more than likely compresses a smaller amount.

  6. Radius rod - Wikipedia

    en.wikipedia.org/wiki/Radius_rod

    Radius rod. A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing) on one end to the wheel carrier or axle, on the other to the chassis or unibody of the vehicle.

  7. MacPherson strut - Wikipedia

    en.wikipedia.org/wiki/MacPherson_strut

    A simple MacPherson strut suspension on the left front wheel of a rear-wheel drive vehicle. The front of the vehicle is at bottom right of the image. Upper green: Vehicle body/strut interface Red: Steering knuckle or hub carrier Blue: Lower control arm or track control arm Light blue: Steering gear tie rod or track rod Lower purple: Radius rod

  1. Ads

    related to: control arm for suspension