Search results
Results from the WOW.Com Content Network
Ensure that the machine is halted by lowering and raising the Halt switch; the front panel "RUN" light should then be off. Set the 12 data switches to 0030 (Octal address 30), depress the Load Address ("ADDR LOAD") switch. The address lights will change to "0030". Set the switches to 6743, raise the Deposit switch. The data lights will show ...
Wake-on-LAN (WoL or WOL) is an Ethernet or Token Ring computer networking standard that allows a computer to be turned on or awakened from sleep mode by a network message. It is based upon AMD 's Magic Packet Technology , which was co-developed by AMD and Hewlett-Packard, following its proposal as a standard in 1995.
Alternately, the light designer can control these same lights with light cues from the lighting control console so that, for instance, the transition from houselights being up before a show starts and the first light cue of the show is controlled by one system.
Power management is a feature of some electrical appliances, especially copiers, computers, computer CPUs, computer GPUs and computer peripherals such as monitors and printers, that turns off the power or switches the system to a low-power state when inactive.
Timers can be used to turn off standby power to devices that are unused on a regular schedule. Switches that turn the power off when the connected device goes into standby, [30] or that turn other outlets on or off when a device is turned on or off are also available. Switches can be activated by sensors.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Watching the lights allows one to follow the instructions and the changing data as it runs the Squares program displayed on the panels. In computer jargon, blinkenlights are diagnostic lights on front panels of old mainframe computers. More recently the term applies to status lights of modern network hardware (modems, network hubs, etc.). [1]
Early electronic computer front panels were fitted with an array of light bulbs where the state of each particular bulb would indicate the on/off state of a particular register bit inside the computer. This allowed the engineers operating the computer to monitor the internal state of the machine, so this panel of lights came to be known as the ...