enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

3. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Three different international-standard two-hole punches. A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves).

4. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.

5. Punchcutting - Wikipedia

   en.wikipedia.org/wiki/Punchcutting

   Punchcutting is a craft used in traditional typography to cut letter punches in steel as the first stage of making metal type. [1] Steel punches in the shape of the letter would be used to stamp matrices into copper, which were locked into a mould shape to cast type. Cutting punches and casting type was the first step of traditional typesetting ...

6. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   The punch force required to punch a piece of sheet metal can be estimated from the following equation: [4] F = 0.7 t L ( U T S ) {\displaystyle F=0.7tL(UTS)} Where t is the sheet metal thickness, L is the total length sheared (perimeter of the shape), and UTS is the ultimate tensile strength of the material.

7. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]