Search results
Results from the WOW.Com Content Network
Cutaway side-view diagram of an axial piston pump 3-D rendering of an axial piston pump with the parts labeled Animation of an axial piston pump in operation. An axial piston pump has a number of pistons (usually an odd number) arranged in a circular array within a housing which is commonly referred to as a cylinder block, rotor or barrel.
An axial-flow pump for industrial use. An axial-flow pump, or AFP, is a common type of pump that essentially consists of a propeller (an axial impeller) in a pipe.The propeller can be driven directly by a sealed motor in the pipe or by electric motor or petrol/diesel engines mounted to the pipe from the outside or by a right-angle drive shaft that pierces the pipe.
Diagram of an axial piston pump. Author:Evan Mason 2010. NOTE: the yellow swash plate does not rotate. The only rotating part is the green cylinder block and the red ...
Piston pump compared to a plunger pump. A piston pump is a type of positive displacement pump where the high-pressure seal reciprocates with the piston. [1] Piston pumps can be used to move liquids or compress gases. They can operate over a wide range of pressures. High pressure operation can be achieved without adversely affecting flow rate.
The total pressure may have gravitational, static pressure and kinetic energy components; i.e. energy is distributed between change in the fluid's gravitational potential energy (going up or down hill), change in velocity, or change in static pressure. η is the pump efficiency, and may be given by the manufacturer's information, such as in the ...
Piston pumps can be made variable-displacement by inserting springs inline with the pistons. The displacement is not positively controlled, but decreases as back-pressure increases. Another variation is the variable-displacement vane pump, a type that has found usage in motor vehicle automatic transmissions, such as the General Motors Hydra-Matic.
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
There are two common types of pumps used in turbopumps: a centrifugal pump, where the pumping is done by throwing fluid outward at high speed, or an axial-flow pump, where alternating rotating and static blades progressively raise the pressure of a fluid. Axial-flow pumps have small diameters but give relatively modest pressure increases.