Search results
Results from the WOW.Com Content Network
English: The Regulations require an employer who provides for use, or whose employee uses, a conventional tower crane at work on a construction site, to notify the Health and Safety Executive (“the Executive”) of information relating to the conventional tower crane mentioned in the Schedule to these Regulations.
A specialty example of a climbing crane was introduced by Lagerwey Wind and Enercon [This paragraph needs citation(s)] to construct a wind turbine tower, where instead of erecting a large crane a smaller climbing crane can raise itself with the structure's construction, lift the generator housing to its top, add the rotor blades, then climb down.
A ring crane is a form of large construction crane with a luffing jib. It is distinguished by its slew pivot [ i ] being in the form of a ring-shaped track, rather than a narrow central spindle. The broad base this gives to the slewing section above allows it to slew whilst carrying extremely heavy loads.
This page was last edited on 10 January 2013, at 09:16 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
The operator's cabin hosts a display showing the tower crane's position, movement and operating area. Where the tower crane’s operating area overlaps with other cranes or prohibited zones these are also displayed. The system alerts the operator when the crane is approaching a prohibited area or another crane. [9]
EOT cranes are extensively used in warehouses and industry. [2] An EOT crane is able to carry heavy objects to anywhere needed on the factory floor, and can also be used for lifting. However, it cannot be used in every industry. The working temperature is to limited to a range between -20°C to 40°C. [citation needed]
Derelict Smith (Rodley) crane, on the Manchester Bolton & Bury Canal. The cranes were used in countless docks, railway yards, quarries and construction sites, both at home and overseas. Some of the largest construction projects to use Smith cranes were the Manchester Ship Canal, the Aswan Low Dam, and the Sudan Barrage. [5]
An overhead crane, commonly called a bridge crane, is a type of crane found in industrial environments. An overhead crane consists of two parallel rails seated on longitudinal I-beams attached to opposite steel columns by means of brackets. The traveling bridge spans the gap. A hoist, the lifting component of a crane, travels along the bridge.