Search results
Results from the WOW.Com Content Network
Stucco or render is a construction material made of aggregates, a binder, and water. Stucco is applied wet and hardens to a very dense solid. It is used as a decorative coating for walls and ceilings, exterior walls, and as a sculptural and artistic material in architecture.
Siding or wall cladding is the protective material attached to the exterior side of a wall of a house or other building. Along with the roof, it forms the first line of defense against the elements, most importantly sun, rain/snow, heat and cold, thus creating a stable, more comfortable environment on the interior side.
The predominant method of EIFS applied today is EIFS with Drainage, which provides a way for moisture accumulated in the wall cavity to evacuate. [9] EIFS is not stucco despite often called "synthetic stucco". Traditional stucco is a centuries-old, hard, dense, thick, non-insulating material which consists of aggregate, a binder, and water.
Producers report an average R-value of 2.0 - 5.5, significantly more than that of other siding products including fiber cement, brick and stucco. Homeowners also report insulated siding serves as a noise barrier to external sound. Insulated vinyl siding with added fan fold foam board insulation raises the R-value to 3.5 - 7.5.
Clay wall plaster and clay wall paint have a very high deposition velocity. In general, fleecy and porous materials exhibit higher deposition velocities than smooth sealed surfaces. The high deposition velocities exhibited by clay wall plaster or paint may be due to iron or aluminum catalyzed decomposition of ozone.
Pebbledash Pebbledashing Rock dash stucco. Roughcast or pebbledash is a coarse plaster surface used on outside walls that consists of lime and sometimes cement mixed with sand, small gravel and often pebbles or shells. [1] The materials are mixed into a slurry and are then thrown at the working surface with a trowel or scoop.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.