Ads
related to: locks for electrical meter box and disconnect cable connectors set 4
Search results
Results from the WOW.Com Content Network
Each camlock connector carries a single phase, pole, or conductor; multiple camlock connectors will be used to make a complete electrical supply or circuit. The most common form is the 16 series, rated at 400 amperes with 105 °C terminations. Also in common use is the 15 series (mini-cam), rated at 150 amperes.
Line Source connectors (top) mated with Line Drain connectors (bottom). Panel Drain (female) connectors, for feeding power in to a portable distribution cabinet. Powerlock is a range of single-pole electrical connectors used for temporary high-current, low-voltage (up to 1000 V AC) applications, [2] similar to but considered safer than camlock ...
At the end of 2020, Neutrik released a re-designed version of the original PowerCON which is capable of connecting/disconnecting under load when mated with the corresponding connectors, allowing a claim of compliance with IEC EN 60320-1. Cable connectors with breaking capacity are recognizable due to the '-1' in their article number like NAC3FCA-1.
The cable connectors and sockets are keyed and colour-coded, according to the voltage range and frequency used; common colours for 50–60 Hz AC power are yellow for 100–130 volts, blue for 200–250 volts, and red for 380–480 volts. The blue fittings are often used for providing weather-proofed exterior sockets for outdoor apparatus.
MC4 connectors are successors of the MC3 Connectors, which were developed by Multi-Contact in 1996. MC3 is the abbreviation of Multi-Contact and its size 3mm PV connector with 3 mm contact pin. MC3 had certification ratings of (1000VIEC/600V UL) and 30A (10AWG PV Cable). The MC3 connectors were discontinued in 2016.
Twist-on wire connectors are a type of electrical connector used to fasten two or more low-voltage (or extra-low-voltage) electrical conductors. They are widely used in North America and several European countries in residential, commercial and industrial building power wiring, but have been banned in some other jurisdictions.
Shrouded cable glands going into a flow meter. Split cable gland KVT for routing pre-terminated cables. A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]
These connectors are common in live event power distribution. Many event production companies use power distributors with camlock connectors for feeder cable, and 12 or more L21-30 connectors which can each be broken out to three individual 120 V circuits via the use of a stringer box. [citation needed]
Ads
related to: locks for electrical meter box and disconnect cable connectors set 4