Ads
related to: how to tell if your torque converter is bad
Search results
Results from the WOW.Com Content Network
Idle creep, sometimes called idle speed or just creep [citation needed] is the default speed that a vehicle with an automatic transmission will move either forward or in reverse when the change lever is in D for drive or R for reverse and the foot is taken off the brake pedal but the accelerator pedal is not depressed.
At stall, the torque converter can produce maximum torque multiplication if sufficient input power is applied (the resulting multiplication is called the stall ratio). The stall phase actually lasts for a brief period when the load (e.g., vehicle) initially starts to move, as there will be a very large difference between pump and turbine speed.
Known as an input speed sensor (ISS). This sensor sends a varying frequency signal to the TCU to determine the current rotational speed of the input shaft or torque converter. The TCU uses the input shaft speed to determine slippage across the torque converter and potentially to determine the rate of slippage across the bands and clutches. This ...
Some areas of failure on this transmission include leaks in the oil filling tube by removing the cap incorrectly, damage to plastic internals due to fluid over-temperature conditions, leaks in the transmission oil cooler, internal fluid pressure leaks from torn piston diaphragms, worn piston bores for solenoids in aluminum valve body, and the resulting worn clutches and bands.
At the appropriate time, the R-1-3-5 clutch is disengaged and the 2-4-6 clutch is engaged. While in second gear, the other side shifts from first to third. The process is repeated with none of the efficiency loss normally associated with torque converters and, in theory, provides quick smooth shifts.
Beginning in 1998 a new 300mm torque converter with improved higher-capacity internals, 300mm style input shaft, and 300mm style pump was also introduced on models coupled to a Gen III Small Block. The 4L60E is rated to handle up to 360 ft⋅lb (490 N⋅m) of torque. It weighs 133 pounds without transmission fluid. [1]
No service fluids were developed and for a short time, DEXRON fluids approved by General Motors were considered acceptable. With continuing changes and improvements in transmission design, a centrifugal lock-up torque converter clutch was introduced into the C5 transmission to smooth engine vibrations sensed by the occupant of the vehicle.
Pages in category "Torque converters" The following 5 pages are in this category, out of 5 total. This list may not reflect recent changes. ...
Ads
related to: how to tell if your torque converter is bad