Search results
Results from the WOW.Com Content Network
The temperature of the cooling air may range from well below freezing to 50 °C. Further, while engines in long-haul boat or rail service may operate at a steady load, road vehicles often see widely varying and quickly varying load. Thus, the cooling system is designed to vary cooling so the engine is neither too hot nor too cold.
In effect, the evaporative version is operating between 80 °C and 560 °C, a 480 °C effective temperature difference. Such a system can be effective even with much smaller amounts of water. The downside to the evaporative cooling system is the area of the condensers required to cool the steam back below the boiling point. As steam is much ...
This is often referred to as "auto-refrigeration" and is the basis of most conventional vapor compression refrigeration systems. If the saturated liquid is a multi-component liquid (for example, a mixture of propane , isobutane and normal butane ), the flashed vapor is richer in the more volatile components than is the remaining liquid.
An expansion tank, also known as "overflow bottle", is also used in the cooling system of most internal combustion engines, to allow the coolant, such as antifreeze, and the air in the system to expand with rising temperature and pressure. The tank is also called a "coolant recovery tank", since it prevents venting and permanent loss of coolant ...
A fan clutch is a thermostatic engine cooling fan that can freewheel at low temperatures when cooling is not needed, allowing the engine to warm up faster, relieving unnecessary load on the engine. As temperatures increase, the clutch engages so that the fan is driven by engine power and moves air to cool the engine.
The 2016 Chevrolet Malibu Hybrid car features an Exhaust gas Heat Recovery (EGHR) system to accelerate coolant heat up time. This gives faster heat up of the engine coolant which in turn heats up the engine faster. Less fuel is used giving reduced emissions. This will also quicken cabin heating warm up for passenger comfort and window defrosting.
Common absorption refrigerators use a refrigerant with a very low boiling point (less than −18 °C (0 °F)) just like compressor refrigerators.Compression refrigerators typically use an HCFC or HFC, while absorption refrigerators typically use ammonia or water and need at least a second fluid able to absorb the coolant, the absorbent, respectively water (for ammonia) or brine (for water).
It traverses the high-heat throat region and exits near the injector face. These passages are created either by brazing cooling tubes to the thrust chamber or by milling channels along the chamber walls. The cross-sections of these passages are smaller, increasing the coolant velocity and maximizing cooling efficiency in high-heat areas. [6]