Search results
Results from the WOW.Com Content Network
Where t is the solidification time, V is the volume of the casting, A is the surface area of the casting that contacts the mold, n is a constant, [clarification needed] and B is the mold constant. This relationship can be expressed more simply as: = Where the modulus M is the ratio of the casting's volume to its surface area:
Injection moulding (U.S. spelling: injection molding) is a manufacturing process for producing parts by injecting molten material into a mould, or mold. Injection moulding can be performed with a host of materials mainly including metals (for which the process is called die-casting ), glasses , elastomers , confections , and most commonly ...
MFI Measuring device. The Melt Flow Index (MFI) is a measure of the ease of flow of the melt of a thermoplastic polymer.It is defined as the mass of polymer, in grams, flowing in ten minutes through a capillary of a specific diameter and length by a pressure applied via prescribed alternative gravimetric weights for alternative prescribed temperatures.
Melting zone (also called the transition or compression zone): most of the polymer is melted in this section, and the channel depth gets progressively smaller. Metering zone (also called the melt conveying zone): this zone melts the last particles and mixes to a uniform temperature and composition.
The melt flow rate (MFR) or melt flow index (MFI) is a measure of molecular weight of polypropylene. The measure helps to determine how easily the molten raw material will flow during processing. Polypropylene with higher MFR will fill the plastic mold more easily during the injection or blow-molding production process.
The molding of plastics by necessity occurs at high temperatures (routinely 200 °C or higher) due to the low viscosity of plastics in fluid form (this issue can be addressed to some extent by the addition of plasticizers to the melt, which is a secondary function of a plasticizer). Once plastic is in the mold, it must be cooled to a ...
Multi-material injection molding (MMM) is the process of molding two or more different materials into one plastic part at one time. [1] As is the case in traditional injection molding, multi material injection molding uses materials that are at or near their melting point so that the semi-liquidous material can fill voids and cavities within a pre-machined mold, thus taking on the desired ...
It differs from the polytetrafluoroethylene (PTFE) resins in that it is melt-processable using conventional injection molding and screw extrusion techniques. [2] Fluorinated ethylene propylene was invented by DuPont and is sold under the brandname Teflon FEP. Other brandnames are Neoflon FEP from Daikin or Dyneon FEP from Dyneon/3M.