Search results
Results from the WOW.Com Content Network
Placing the oil pump low-down uses a near-vertical drive shaft, driven by helical skew gears from the camshaft. Some engines, such as the Fiat Twin Cam engine of 1964, began as OHV engines with an oil pump driven from a conventional camshaft in the cylinder block. When the twin overhead cam engine was developed, the previous oil pump ...
The discontinued torque-tube drive was replaced by a new design utilizing an open driveshaft and a four-link axle-location system. [ 16 ] The 1961 Pontiac Tempest was introduced as a new model, featuring an inline 4 coupled to a transaxle via a torque tube, giving it a perfect 50-50 front-rear weight balance.
Glenn Fletcher Tilton (born April 1948, in Washington, D.C.) is a retired American oil and airline industry executive. Tilton spent most of his career working for Texaco, and as CEO guided its merger with Chevron Oil in 2001. He was chairman, president, and CEO of UAL Corporation from 2002 to 2010.
An electronic limited-slip differential will typically have a planetary or bevel gear set similar to that of an open differential and a clutch pack similar to that in a torque sensitive or gerotor pump based differential. In the electronic unit the clamping force on the clutch is controlled externally by a computer or other controller.
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
Differential operation while driving in a straight line: Input torque is applied to the ring gear (purple), which rotates the carrier (purple) at the same speed. When the resistance from both wheels is the same, the planet gear (green) doesn't rotate on its axis (although the gear and its pin are orbiting due to being attached to the carrier).
The oil collects in sump (1), is withdrawn continuously by scavenge pump (2) and travels to the oil tank (3), where gases entrained in the oil separate and the oil cools. Gases (6) are returned to the engine sump. Pressure pump (4) forces the de-gassed and cooled oil (5) back to the engine's lubrication points (7).
For example, most modern gearboxes require a GL-4 oil, and separate differentials (where fitted) require a GL-5 oil. While they take the same form, the viscosity grades for gear oils are on a different scale than the viscosity grades for an engine oil. The viscometrics for gear oils are standardized in SAE J306.